Deck Calculator: Estimate deck boards, joists, and square footage from deck size, board width, gap, and joist spacing
Deck Calculator is the tool for one job: estimate deck boards, joists, and square footage from deck size, board width, gap, and joist spacing. This guide covers the inputs to gather, one pass you can check, and the point where the result stops being enough.
What to bring to the Deck Calculator
You need the deck length and width, the board width, the gap between boards, and the joist spacing.
Deck Calculator runs in your browser. The file or the figures stay on your device.
A worked pass with the Deck Calculator
Boards run across the joists. A wider gap means fewer boards and a slightly different count. Joists are spaced along the other direction, often 16 inches on center, so the count is the span divided by the spacing, plus one for the end.
Do that pass with a case you already understand. Then replace it with the real case. Changing one input at a time is how you see which field actually moved the result.
How to check the result
Square footage should stay length times width even when the board count changes. If the area moves when you only change the gap, the fields are tied together incorrectly.
Where the Deck Calculator stops
This is a material count. It does not design the ledger, the footings, or the load.
If your decision depends on a rule this page does not mention, a lender, a clinic, a teacher, a client, or the vendor of the file, use their rule. Keep this result as the draft you compare against that rule.
Questions
What does the Deck Calculator do?
It is there to estimate deck boards, joists, and square footage from deck size, board width, gap, and joist spacing. The form on the Deck Calculator page is the place you do that.
How do I know the Deck Calculator result is usable?
Square footage should stay length times width even when the board count changes. If the area moves when you only change the gap, the fields are tied together incorrectly.
What should I not trust the Deck Calculator to decide?
This is a material count. It does not design the ledger, the footings, or the load.
When the next step is a different tool
- CFM Calculator — Calculate airflow CFM from room volume and air changes per hour for a fan, hood, or workshop.
- kW to kVA Calculator — Convert kilowatts to kVA with power factor, and estimate single-phase or three-phase amps.
- Aquarium Calculator — Convert tank dimensions to gallons and liters, plus heater watts, water-change volume, and salt dose.