Kerf Calculator: See how many pieces a board yields after saw kerf, and how many boards to buy
Kerf Calculator is the tool for one job: see how many pieces a board yields after saw kerf, and how many boards to buy. This guide covers the inputs to gather, one pass you can check, and the point where the result stops being enough.
What to bring to the Kerf Calculator
Kerf is the width the saw blade turns into sawdust. Each cut consumes one kerf. The number of pieces from one board is the usable length divided by piece length plus kerf, with care about the last piece, which may not need a trailing kerf.
Kerf Calculator runs in your browser. The file or the figures stay on your device.
A worked pass with the Kerf Calculator
A 96 inch board, 10 inch pieces, and a 1/8 inch kerf does not yield 9.6 pieces. After eight pieces you have used eight lengths and seven or eight kerfs, depending on whether the last cut is required. The page's piece count should be a whole number you can actually cut.
Do that pass with a case you already understand. Then replace it with the real case. Changing one input at a time is how you see which field actually moved the result.
How to check the result
Set the kerf to 0. The count should match the board length divided by the piece length, ignoring the blade. Put the kerf back and the count should stay the same or drop.
Where the Kerf Calculator stops
A bowed board or a trimmed factory end eats length this page does not see.
If your decision depends on a rule this page does not mention, a lender, a clinic, a teacher, a client, or the vendor of the file, use their rule. Keep this result as the draft you compare against that rule.
Questions
What does the Kerf Calculator do?
It is there to see how many pieces a board yields after saw kerf, and how many boards to buy. The form on the Kerf Calculator page is the place you do that.
How do I know the Kerf Calculator result is usable?
Set the kerf to 0. The count should match the board length divided by the piece length, ignoring the blade. Put the kerf back and the count should stay the same or drop.
What should I not trust the Kerf Calculator to decide?
A bowed board or a trimmed factory end eats length this page does not see.
When the next step is a different tool
- CFM Calculator — Calculate airflow CFM from room volume and air changes per hour for a fan, hood, or workshop.
- kW to kVA Calculator — Convert kilowatts to kVA with power factor, and estimate single-phase or three-phase amps.
- Aquarium Calculator — Convert tank dimensions to gallons and liters, plus heater watts, water-change volume, and salt dose.