Miter Angle Calculator: Find the miter saw angle and interior corner for a square, hexagon, octagon, or any equal-sided frame
Miter Angle Calculator is the tool for one job: find the miter saw angle and interior corner for a square, hexagon, octagon, or any equal-sided frame. This guide covers the inputs to gather, one pass you can check, and the point where the result stops being enough.
What to bring to the Miter Angle Calculator
For a frame with equal sides, the miter angle on each piece is half of the corner. A square has 90 degree corners, so each miter is 45 degrees.
Miter Angle Calculator runs in your browser. The file or the figures stay on your device.
A worked pass with the Miter Angle Calculator
A regular hexagon has interior corners of 120 degrees, so each miter is 60 degrees from the square reference people expect, which is a 30 degree cut off square. Read the label: 'miter angle' and 'degrees off 90' are not the same number.
Do that pass with a case you already understand. Then replace it with the real case. Changing one input at a time is how you see which field actually moved the result.
How to check the result
A square should show 45 degrees. If it does not, you are reading the interior corner instead of the saw setting.
Where the Miter Angle Calculator stops
The saw setting assumes equal sides and a flat frame. A non-equal frame needs a different calculation.
If your decision depends on a rule this page does not mention, a lender, a clinic, a teacher, a client, or the vendor of the file, use their rule. Keep this result as the draft you compare against that rule.
Questions
What does the Miter Angle Calculator do?
It is there to find the miter saw angle and interior corner for a square, hexagon, octagon, or any equal-sided frame. The form on the Miter Angle Calculator page is the place you do that.
How do I know the Miter Angle Calculator result is usable?
A square should show 45 degrees. If it does not, you are reading the interior corner instead of the saw setting.
What should I not trust the Miter Angle Calculator to decide?
The saw setting assumes equal sides and a flat frame. A non-equal frame needs a different calculation.
When the next step is a different tool
- CFM Calculator — Calculate airflow CFM from room volume and air changes per hour for a fan, hood, or workshop.
- kW to kVA Calculator — Convert kilowatts to kVA with power factor, and estimate single-phase or three-phase amps.
- Aquarium Calculator — Convert tank dimensions to gallons and liters, plus heater watts, water-change volume, and salt dose.